Skip to main content
Hardware Math

What PSU do you need for a AMD Radeon RX 5700 XT?

The AMD Radeon RX 5700 XT has a vendor-published board power (TGP/TBP) of about 225 W. Sizing a power supply from that figure and a typical companion system (a 125 W-class CPU plus standard ATX accessories, ~242 W), here is what we recommend.

Verified against AMD’s official specification View the spec · checked

Recommendations are planning estimates, not electrical or purchasing advice. The hardware figures behind them are vendor-published; your exact board-partner model and build can still differ.

Recommended (comfortable)

650 W

Standard headroom for transient spikes and a little future room.

Minimum

550 W

Smallest quality PSU tier we would pair with this card in a typical build.

GPU board power

225 W

Vendor TGP/TBP — a conservative ceiling, not typical gaming draw.

Vendor-recommended PSU

600 W

The wattage the GPU vendor lists — deliberately conservative.

Power connector

1× PCIe 8-pin + 1× PCIe 6-pin. Use native PSU cables and confirm the layout on your exact board-partner model. See connector & ATX 3.x details →

Why 650 W for this card

The AMD Radeon RX 5700 XT's draw is not flat. Brief spikes above the rated board power are normal, and they are short enough that a wall meter never shows them — but a power supply sitting close to its limit can trip on one. That is what the headroom in these figures is for: 225 W is the sustained ceiling, not the worst instant. This card feeds from standard PCIe connectors, so any quality supply with the right cable count works; there is no 16-pin cable to source. At 225 W a quality unit of the recommended wattage handles transients without drama; an ATX 3.x supply adds margin but is not essential. We do not publish a spike figure for the AMD Radeon RX 5700 XT because the manufacturer does not publish one.

On the recommended 650 W supply, a Ryzen 7 9800X3D paired with the AMD Radeon RX 5700 XT draws roughly 504 W under load — about 78% of the unit's rating. The 80 PLUS programme certifies efficiency at 20%, 50% and 100% load, and units are typically at their best around the middle of that range, so this sits in a sensible place: enough margin for transients without paying for capacity that never gets used.

The manufacturer recommends 600 W; our comfortable figure is 650 W, 50 W higher. Vendor recommendations assume a mainstream companion system, while our figure adds standard headroom on top of a typical build. 600 W is not wrong — but if you are running a power-hungry CPU or want the supply loafing rather than working, the larger unit is the safer buy.

Pairing this card with different CPUs

The CPU does change the answer here. With a Ryzen 5 7600 this build sits on a 550 W supply, but moving to a Ryzen 7 9800X3D (162 W peak) pushes the estimate to 650 W. If you are pairing this GPU with a high-power CPU, budget for the larger unit.

CPU CPU peak System load Recommended PSU
Ryzen 5 7600 88 W 430 W 550 W
Ryzen 7 9800X3D 162 W 504 W 650 W
Core i9-14900K 253 W 595 W 750 W

Other popular choices map onto this table rather than changing it: the Ryzen 7 7800X3D has the same 162 W peak as the Ryzen 7 9800X3D, so that row applies to it unchanged; a Core i5-14600K (181 W peak) lands on the same 750 W tier as the Core i9-14900K; a Ryzen 9 9950X (230 W peak) lands on the same 750 W tier as the Core i9-14900K.

Assumes an ATX board, 2 RAM sticks, 1 SSD, 3 fans and a USB allowance, at the standard headroom profile. Change any of it in the calculator.

Cabling this card

This card needs 1× 8-pin plus 1× 6-pin. Run a separate cable from the power supply to each connector rather than using one daisy-chained (pigtail) cable — at 225 W the split puts more current through a single cable than it is comfortable carrying. Never mix modular cables between different supplies; the PSU-side pinouts are not standardised.

AMD reference design (shown); many partner cards use 2x 8-pin. Factory-overclocked cards from board partners can also carry a higher power limit than the reference design, so if your card advertises an OC BIOS, treat the figures here as the floor rather than the ceiling.

Want a number for your exact CPU and parts? Open the full PSU Calculator with this GPU pre-selected →

The standards behind these numbers

Worth knowing

AMD official TBP 225 W (reference blower card).

Board-power source: AMD official specification; multi-agent web verification 2026-07-15. Last updated: 2026-07-15.

Frequently asked questions

What size PSU do I need for a AMD Radeon RX 5700 XT?

For a typical build that pairs the AMD Radeon RX 5700 XT (about 225 W board power) with a 125 W-class CPU and standard accessories, plan for at least a 550 W power supply. A 650 W unit gives comfortable headroom for transient spikes and future upgrades. These are estimates — verify against your exact parts.

How much power does the AMD Radeon RX 5700 XT draw?

Its vendor-published board power (TGP/TBP) is about 225 W. That is a conservative ceiling used for PSU sizing, not the typical draw you would see while gaming.

Is a 600 W PSU enough for a AMD Radeon RX 5700 XT?

AMD Radeon RX 5700 XT's manufacturer lists a 600 W PSU recommendation. That figure is deliberately conservative to cover weaker units and power-hungry CPUs, so a quality 600 W supply is a safe choice. Our own estimate for a typical build is a 550 W minimum and 650 W for comfort.

Does the CPU change what PSU the AMD Radeon RX 5700 XT needs?

Yes. With a Ryzen 5 7600 the estimate is 550 W, while a Core i9-14900K (253 W peak) takes it to 750 W.

Why does this differ from AMD Radeon RX 5700 XT's official PSU recommendation?

The manufacturer lists 600 W and our comfortable figure is 650 W. Vendor guidance assumes a mainstream companion system; ours adds standard headroom to a typical build. Both are shown on this page so you can judge.